When I woke up yesterday, the thermometer registered 6 degrees F (-14 C) and I knew we would get a full day in of harvest. With the ground frozen hard, we continued our second pass over the pecan grove (photo at right).
All day yesterday, you could hear the hum of pecan harvesters working in area commercial groves. Because we have had such a wet harvest season this year, many pecan groves were being harvested for the very first time.
One of the problems with harvesting pecans from frozen ground is that you also end up harvesting chunks of frozen soil along with the nuts. The photo at left shows a close-up of our second harvest nuts as they appear straight out of the harvester. You can see how many chunks of frozen soil were harvested along with nuts and small sticks. If you look closely you can even see ice crystals within the dirt clods.
The harvested nuts need to be cleaned while still frozen so the clumps of soil can be cleaned out before they thaw and turn into mud. The photo at left was taken two hours after I brought a sample of our harvest inside. The soil clods have thawed and turned into piles of slimy goo that would quickly coat the nuts if run through our cleaning system.
Friday, January 9, 2015
Wednesday, January 7, 2015
Time to think about tree thinning
Over the past several years, I have outlined our plan for thinning a block of Kanza trees. Early on, we recognized that the trees in this block were not all growing at the same rate. Portions of the orchard started to crowd faster than other areas as the trees responded to soil variation within this 3 acre tract of land. We devised a total orchard thinning plan but we have been removing trees only when adjacent trees start to crowd.
Yesterday, as the sun was shinning and the temperatures reached a balmy 32 degrees F, I walked through the Kanza block to get a feel for which areas would require thinning this winter (photo at right). Just walking through the orchard its sometimes hard to visualize which sections will require thinning next.
One method I've used to help plan my next thinning cuts is to plot out the trunk diameters of every tree in the orchard (figure at left). In the figure, each tree in the orchard is portrayed by a green circle that graphically represents trunk diameter as measured after leaf drop in 2014. All the blank spots on the map are the locations where trees were removed previously.
Using the map as a guide, I go out to the orchard to visually determine which trees actually need to be removed. I'll stand between two adjacent trees and look up. If the branches are close to touching its time to thin. Let me show you what I mean.
On the map at left, I have placed a red box around adjacent trees at two locations in the orchard. At each location, I laid down on the ground between the two trees and took a wide-angle photo straight up. Tree 6-10 is 10.3 inches in diameter while tree 7-10 is 11.0 inches. Just a couple of trees to the south, tree 6-12 has a DBH of 9.2 inches and tree 7-12 is 8.3 inches in diameter. From the map it looks like trees 6-10 and 7-10 are almost touching while trees 6-12 and 7-12 still have some room to grow. Now lets look at the photos.
The photo at right shows how close the canopies of trees 6-10 and 7-10 are to each other. The dormant stems of each tree are not touching each other yet but add another summer of stem growth and a full load of leaves and you would see a closed canopy during the summer of 2015. I'll be thinning some trees out of this area of the orchard.
Moving down the row to trees 6-12 and 7-12, the photo reveals that there is still plenty of space between these two trees (photo at right). In this case, I won't need to thin trees in this portion of the orchard for a year or two.
We have been thinning this orchard a little bit at a time since 2012. In that time, I've come to realize that our Kanza trees start to crowd when trunk diameters of adjacent trees both exceed 10 inches. However, you must remember thinning decisions should be based soley on your particular soil type, initial tree spacing, and cultivar. We started this Kanza block at a close tree spacing of 30 feet x 30 feet. The closer the initial tree spacing, the smaller the diameter the trees will be when thinning becomes necessary.
Yesterday, as the sun was shinning and the temperatures reached a balmy 32 degrees F, I walked through the Kanza block to get a feel for which areas would require thinning this winter (photo at right). Just walking through the orchard its sometimes hard to visualize which sections will require thinning next.
One method I've used to help plan my next thinning cuts is to plot out the trunk diameters of every tree in the orchard (figure at left). In the figure, each tree in the orchard is portrayed by a green circle that graphically represents trunk diameter as measured after leaf drop in 2014. All the blank spots on the map are the locations where trees were removed previously.
Using the map as a guide, I go out to the orchard to visually determine which trees actually need to be removed. I'll stand between two adjacent trees and look up. If the branches are close to touching its time to thin. Let me show you what I mean.
On the map at left, I have placed a red box around adjacent trees at two locations in the orchard. At each location, I laid down on the ground between the two trees and took a wide-angle photo straight up. Tree 6-10 is 10.3 inches in diameter while tree 7-10 is 11.0 inches. Just a couple of trees to the south, tree 6-12 has a DBH of 9.2 inches and tree 7-12 is 8.3 inches in diameter. From the map it looks like trees 6-10 and 7-10 are almost touching while trees 6-12 and 7-12 still have some room to grow. Now lets look at the photos.
The photo at right shows how close the canopies of trees 6-10 and 7-10 are to each other. The dormant stems of each tree are not touching each other yet but add another summer of stem growth and a full load of leaves and you would see a closed canopy during the summer of 2015. I'll be thinning some trees out of this area of the orchard.
Moving down the row to trees 6-12 and 7-12, the photo reveals that there is still plenty of space between these two trees (photo at right). In this case, I won't need to thin trees in this portion of the orchard for a year or two.
We have been thinning this orchard a little bit at a time since 2012. In that time, I've come to realize that our Kanza trees start to crowd when trunk diameters of adjacent trees both exceed 10 inches. However, you must remember thinning decisions should be based soley on your particular soil type, initial tree spacing, and cultivar. We started this Kanza block at a close tree spacing of 30 feet x 30 feet. The closer the initial tree spacing, the smaller the diameter the trees will be when thinning becomes necessary.
Labels:
tree spacing
Wednesday, December 31, 2014
Picking on frozen ground
Rain, snow and endless days of damp cloudy weather has made the 2014 harvest season difficult. When I think back over this year's harvest season, we've had only 8 days of suitable conditions for mechanical harvest. So when the ground froze hard last night, we greased up the harvester and continued our second harvest (photo above). This year, we are collecting about 150 lbs./acre during our second pass over the orchard floor.
Picking on frozen ground is a little tricky. Besides pecans, the harvester picks up small clumps of frozen mud. As long as the temperatures stay below 32 degrees F, the mud stays solid and the nuts remain relatively clean. Let those mud balls thaw out and you quickly have a mess of muddy pecans. To avoid potential mud problems, we run the nuts through our cleaning system as soon as we have collected a hopper full of second-picking nuts. Getting those frozen mud balls out of the sack as soon as possible is critical. Thankfully, the cleaning reel we inserted into our cleaning system removes most of the mud balls before the nuts get to the inspection table.
Picking on frozen ground is a little tricky. Besides pecans, the harvester picks up small clumps of frozen mud. As long as the temperatures stay below 32 degrees F, the mud stays solid and the nuts remain relatively clean. Let those mud balls thaw out and you quickly have a mess of muddy pecans. To avoid potential mud problems, we run the nuts through our cleaning system as soon as we have collected a hopper full of second-picking nuts. Getting those frozen mud balls out of the sack as soon as possible is critical. Thankfully, the cleaning reel we inserted into our cleaning system removes most of the mud balls before the nuts get to the inspection table.
Labels:
harvest
Tuesday, December 30, 2014
Posey pecan: early history and current observations
| Posey 2014 |
The early 1900's was an exciting time for the naming and propagating of northern pecan cultivars. Names we know today, such as Major, Greenriver, and Posey, were first popularized back in those days. However, other cultivars from that era have largely disappeared from modern pecan orchards including; Busseron, Butterick, Hodge, Indiana, Kentucky, Niblack, and Warrick. It is interesting to me that Posey has survived so long despite some obvious flaws as a pecan cultivar. In 1925, Prof. A.S. Colby, from the University of Illinois stated, "The Posey is said to be the easiest of the northern cultivars to crack and is of good size. It has the reputation, however, of being a shy bearer."
I have also noticed that Posey never sets a really heavy pecan crop but I think a more serious cultivar defect is that Posey produces dark colored kernels. In the photo at left, you can see how dark this year's Posey kernels are as compared to the current season's Kanza kernels. Since dark kernel color is associated with old or rancid pecan kernels, it has become increasingly difficult to market perfectly tasty Posey nut meats to the consumer.
| Posey kernels |
In 1923, former NNGA President, T.P. Littlepage, made these observations about Posey. "The parent Posey tree grows in Indiana, and I had the pleasure of naming it. That tree is a good bearer, and it is the thinnest-shelled northern-grown pecan with which I am familiar. It is a very beautiful nut, with the exception that frequently one side of the kernel will not fill out as it does on the other side. It is not defective, but simply deficient." In the many years of growing and shelling Posey, I had never noticed that Posey produces kernel halves of unequal length. However, this year I took the time to carefully remove the shell from several Posey nuts. The photo above shows two examples of what I found. In every case, one half of the Posey kernel was shorter than the other. The difference was sometimes pronounced (nut at left) and at other times only slight (nut at right). Looks like Mr. Littlepage was right.
Posey has a couple of unique characteristics that make field identification of the cultivar easy. Posey nuts are surrounded by a thick, course-textured shuck that features prominent "wings" along the suture lines (photo at left). Posey nuts have dark colored shells and a strongly flattened shape (see photo above).
The bark of Posey trees is also distinctive. In the photo at right, you can easily see the graft union between the seedling pecan rootstock and a Posey scion. The seedling rootstock has furrowed bark typical for pecan trees of this diameter. In sharp contrast, the Posey top exhibits a scaly bark appearance reminiscent of a shagbark hickory.
Posey is a unique cultivar in many ways. However, it is a cultivar that is fading, slowly being replaced by better northern cultivars.
Subscribe to:
Posts (Atom)

